Kia Soul: Front Seat Belt Pretensioner Repair procedures - Front Seat Belt - Body (Interior and Exterior)Kia Soul: Front Seat Belt Pretensioner Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Replacement
   
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
After loosening the mounting bolt, remove the front seat belt upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connector (A), loosen the mounting bolt, and then remove the front seat belt pretensioner (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Replace any damaged clips.
    Front Seat Belt Pretensioner Components and Components Location
    Component Location 1. Front seat belt pretensioner ...

    Height Adjust Components and Components Location
    Component Location 1. Height adjust ...

    See also:

    Mode Control Actuator Description
    The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

    Auto start
    To restart the engine from idle stop mode • Release the brake pedal. or • Move the shift gear to the R (Reverse) position or the sports mode while depressing the brake pedal. The engine will ...

    Power Window Motor Components
    ...