Kia Soul: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior)Kia Soul: Front Seat Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Loosen the front seat assembly mounting bolts (A).

Tightening torque :
34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)

[Front]

[Rear]

2.
Remove the front seat assembly (A).

3.
Disconnect the airbag connector (A), seat heater & power seat switch connector (B) and front seat belt buckle connector (C).
[Driver''s]

[Passenger''s]

4.
Install in the reverse order of removal.
   
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
Set the seat in the rearmost position. Check that each slide is locked, and then temporarily tighten the front mounting bolts.
Set the seat in the foremost position. Check that each slide is locked, and then completely tighten the rear mounting bolts.
Set the seat in the rearmost position again and then completely tighten the front mounting bolts.
Check that the seat operates to and fro smoothly and that the locking portion locks properly.
    Front Seat Assembly Components and Components Location
    Component Location 1. Front seat assembly ...

    Front Seat Shield Outer Cover Components and Components Location
    Component Location 1. Front seat shield outer cover ...

    See also:

    Air bag warning and indicator
    The purpose of the air bag warning light in your instrument panel is to alert you of a potential problem with your air bag - Supplemental Restraint System (SRS). When the ignition switch is turne ...

    Tire traction
    Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. Slow down when ...

    Outside rearview mirror
    Be sure to adjust the mirror angles before driving. Your vehicle is equipped with both lefthand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch. ...