Kia Soul: Front Impact Sensor (FIS) Repair procedures - SRSCM - RestraintKia Soul: Front Impact Sensor (FIS) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
   
Removal of the airbag must be performed according to the precautions / procedures described previously.
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning to work.
2.
Disconnect the front impact sensor connector (A).

3.
Loosen the mounting bolt and then remove the front impact sensor (B) and extension harness.
Installation
   
Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor (B) mounting bolt.

Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

3.
Connect the front impact sensor connector (A).
4.
Reconnect the battery negative cable.
5.
After installing the Front Impact Sensor, confirm proper system operation:
Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
    Side Impact Sensor (SIS) Description and Operation
    Description Side Impact Sensor (SIS) system consists of two P-SIS, installed at each center of front door modules (LH and RH), and two SIS, installed at each center of nearby pillars (LH and RH ...

    See also:

    Positive Crankcase Ventilation (PCV) Valve Removal
    1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). ...

    Front Hub / Knuckle Reassembly
    1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

    Rear Seat Back Cover Component Location
    1. Rear seat back cover [LH] 2. Rear seat back cover [RH] ...