Kia Soul: Front Door Window Glass Replacement - Front Door - Body (Interior and Exterior)Kia Soul: Front Door Window Glass Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Replacement

1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).
3.
Remove the front door window glass mounting hole plug (A).
4.
Before removing the front door glass (C), loosen the mounting bolt (A) as loosely as possible and loosen the mounting bolt (B) completely.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  
•
Be careful not to drop the glass and/or scratch the glass surface.
  
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
5.
Carefully adjust the front door window glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
  
•
When removing the front door glass, be careful not to separate the glass mounting bracket (B).

6.
Install in the reverse order of removal.
  
•
Roll the glass up and down to see if it moves freely without binding.
•
Adjust glass position as needed.
•
Make sure the door lock and opens properly.
•
Replace any damaged clips.
    Front Door Window Glass Component Location
    1. Front door window glass ...

    Front Door Module Component Location
    1. Front door module ...

    See also:

    Warning
    If the vehicle leaves a lane or road edge, the lane marker or road edge you cross will blink on the LCD display and the warning sound is provided. If the driver takes hands off the steering whe ...

    Operating door locks from inside the vehicle
    With the door lock button To unlock a door, push the door lock button (1) to the “Unlock” position. The red mark (2) on the button will be visible. To lock a door, push the door lock ...

    Input Speed Sensor. Specifications
    ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (1.2 ~ 1.8) 0.0472 ~ 0.0709 Output voltage(V) ...