Remove the front door belt inside weatherstrip (A).
3.
Remove the front door window glass mounting hole plug (A).
4.
Before removing the front door glass (C), loosen the mounting
bolt (A) as loosely as possible and loosen the mounting bolt (B)
completely.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
•
Be careful not to drop the glass and/or scratch the glass surface.
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
5.
Carefully adjust the front door window glass (A) until you
can see the bolts, then loosen them. Separate the glass from the glass
run and carefully pull the glass out through the window slot.
•
When removing the front door glass, be careful not to separate the glass mounting bracket (B).
6.
Install in the reverse order of removal.
•
Roll the glass up and down to see if it moves freely without binding.
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Scheduled maintenance service
Follow Normal Maintenance Schedule if the vehicle is usually operated where none
of the following conditions apply. If any of the following conditions apply, follow
Maintenance Under Severe Usage ...