Kia Soul: Front Door Latch Replacement - Front Door - Body (Interior and Exterior) - Kia Soul 2014-2019 PS Service ManualKia Soul: Front Door Latch Replacement

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Replacement

1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

3.
Remove the front door outside handle connector wiring harness (A).

4.
Remove the front door outside handle cable (A).

5.
To remove the front door outside handle base connector (A) after turning it counter clockwise.

6.
Remove the front door outside handle connector wiring harness (A).

7.
Disconnect the front door latch connector (A).
8.
Remove the front door latch assembly (B) by pulling it in the direction of the arrow.

9.
Remove the front door inside handle cage (A).

10.
Remove the front door inside handle cable (A) by pushing it rearward.

11.
Install in the reverse order of removal.
  
Х
Make sure the connector is connected properly.
Х
Make sure the door locks/unlocks and opens/closes properly.
Х
Replace any damaged clips.
    Front Door Latch Component Location
    1. Front door latch ...

    Front Door Belt Inside Weatherstrip Replacement
    1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A ...

    See also:

    GAW (Gross axle weight)
    This is the total weight placed on each axle (front and rear) - including vehicle curb weight and all payload. ...

    105,000 miles or 84 months
    ❑ Inspect air cleaner filter ❑ Inspect air conditioning compressor, air conditioner refrigerant and performance (if equipped) ❑ Inspect cooling system *1 ❑ Inspect dri ...

    Fuel Pressure Control Valve. Description and Operation
    Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...