Kia Soul: Floor Console Assembly Repair procedures - Floor Console - Body (Interior and Exterior)Kia Soul: Floor Console Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Floor Console / Floor Console Assembly Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Pull in the direction of the arrow and remove the gear knob.

Escaping power : 55± 10kgf

2.
Using a screwdriver or remover, remove the console upper cover (A).

3.
Disconnect the indicator connector (A), start/stop button switch connector (B) and multimedia jack connector (C).

4.
Press the locking pin and disconnect EPB connector.

5.
Remove the hole cover (A).

6.
Remove the console side cover (A) by pushing it backward.
[LH]

   
When installing, insert the front of console side cover (B) to hook (A).

[RH]

   
When installing, insert the front of console side cover (B) to took (A).

7.
After loosening the mounting screws and bolts, remove the floor console assembly (A).

8.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Replace any damaged clips.
    Floor Console Assembly Components and Components Location
    Component Location 1. Floor console assembly ...

    Rear Console Cover Components and Components Location
    Component Location 1. Rear console cover ...

    See also:

    Front Door Window Glass Components and Components Location
    Component Location 1. Front door window glass ...

    Auto Light Sensor Inspection
    In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light se ...

    Transaxle Oil Temperature Sensor. Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...