Kia Soul: Electric Parking Brake (EPB) Repair procedures - Parking Brake System - Brake SystemKia Soul: Electric Parking Brake (EPB) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Brake System / Parking Brake System / Electric Parking Brake (EPB) Repair procedures

Removal
1.
Turn ignition OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console assembly.(Refer to Body - “Floor console assembly")
3.
Disconnect the EPB control unit mounting nuts and then remove EPB control unit.

Tighten torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Disconnect the EPB control unit connector (A).
Installation
1.
Install in the reverse order of removal.
2.
After replacing the EPB control unit with a new one, “Variant Coding” procedure must be performed.
3.
Perform the “G-Sensor Calibration” with GDS.
4.
Check that the brake operates normally by pushing the EPB switch more than 3 times after installing the EPB module.
Variant coding
1.
Turn ignition "OFF" and connect GDS.
2.
While ignition "ON" & engine "OFF", select vehicle name and EPB system.
3.
Select EPB Variant coding mode.

4.
Perform the "EPB Variant Coding" procedure with GDS.

5.
Complete the “Variant Coding” procedure.
    Electric Parking Brake (EPB) Schematic Diagrams
    EPB Circuit Diagram (1) EPB Circuit Diagram (2) EPB connector input/output Pin DescriptionPin Description1WC-CAN (High)21G/BCenter Fascia Switch (ElectronicParking Brake Switch (SW3 ...

    EPB Switch Repair procedures
    Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3. Remove the EPB switch assemb ...

    See also:

    Tail Gate Trim Components and Components Location
    Component Location 1. Tail gate trim ...

    SRS components and functions
    The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module* 3. Side air bag modules* 4. Curtain air bag modules* 5. Retractor pre ...

    Spark Plug Installation
    1. Install in the reverse order of removal. Tightening torque: 14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.8 ~ 18.0 Ib-ft) ...