Kia Soul: Cylinder Head Cover Removal
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Cover Removal
| 1. |
Remove the engine cover.
|
| 2. |
Disconnect the battery negative terminal.
|
| 3. |
Disconnect the control wiring harness connectors and fasteners
and remove the wiring harness protectors from the cylinder head cover.
|
| 4. |
Remove the high pressure fuel pump.
(Refer to Engine Control / Fuel System - "High Pressure Fuel Pump")
|
| 5. |
Remove the ignition coils.
(Refer to Engine Electrical System - “Ignition Coil”)
|
| 6. |
Disconnect the positive crankcase ventilation (PCV) hose (A).
|
| 7. |
Remove the cylinder head cover(A), gasket(B).
|
Cylinder Head Cover Components
1. Cylinder head cover
2. Cylinder head cover gasket
3. Cam position sensor
...
Cylinder Head Cover Installation
1.
Install the cylinder head cover (A) with a new gasket (B).
Do ...
See also:
Voice Command List
Common Commands:
These commands can be used in most operations. (However a few commands may not
be available during certain operations)
FM/AM radio commands:
Commands available ...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be ...
Rear Door Belt Inside Weatherstrip Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
...