Kia Soul: Cylinder Block Reassembly - Cylinder Block - Engine Mechanical SystemKia Soul: Cylinder Block Reassembly

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Reassembly

1.
Install in the reverse order of disassembly.
  
In case the cylinder block is replaced with a new one, select the proper crankshaft main bearing and the piston according to the crankshaft journal bore mark and the cylinder bore mark on the cylinder block.
Crankshaft main bearing selection
(Refer to Cylinder Block Assembly - "Crankshaft")
Piston selection
(Refer to Cylinder Block Assembly - "Piston and Connecting Rod")
    Cylinder Block Inspection
    1. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Using a soft brush and solvent, th ...

    See also:

    Warning Lamp Activation
    Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check. T ...

    Checking the engine oil level
    1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

    How vehicle audio works
    AM and FM radio signals are broadcast from transmitter towers located around your city. They are intercepted by the radio antenna on your vehicle. This signal is then received by the radio and s ...