Kia Soul: Crash Pad Lower Panel Replacement - Crash Pad - Body (Interior and Exterior)Kia Soul: Crash Pad Lower Panel Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Replacement

  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
2.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

3.
After loosening the mounting screws, then remove the crash pad lower panel (A) by using a screw driver.

4.
Disconnect the diagnosis connector (A).

5.
Install in the reverse order of removal.
  
Make sure the connector are connected in properly.
Replace any damaged clips.
    Crash Pad Lower Panel Component Location
    1. Crash pad lower panel ...

    Glove Box Housing Component Location
    1. Glove box housing ...

    See also:

    Blower Unit Replacement
    1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. ...

    GAWR (Gross axle weight rating)
    This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAWR ...

    Power Seat Motor Inspection
    Power Seat Motor 1. Disconnect the connectors for each motor. (Refer to Body - "Front Seat Assembly") A : Slide motor B : Fro ...