Kia Soul: Cooling Fan Description - Cooling System - Engine Mechanical SystemKia Soul: Cooling Fan Description

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Description

[Air conditioning type]
The cooling fan operates in 2 stages (HIGH/LOW). The engine control module (ECM) controls the cooling fan according to the coolant temperature, vehicle speed and A/C operation.
[Cooling fan operation conditions]
A/C switch
A/C pressure
[kgf/cm² G (psi G)]
Vehicle speed
[km/h (mph)]
Coolant temperature
[°C (°F)]
Cooling fan speed
OFF

V < 45 (28)
95 ~ 100 (203 ~ 212)
LOW
100 (212) or above
HIGH
45 (28) ≤ V < 80 (49.7)
95 ~ 100 (203 ~ 212)
LOW
100 (212) or above
HIGH
80 (49.7) ≤ V
105 (221) or above
HIGH
ON
P < 6 (85.3)
All
105 (221) or above
HIGH
6 (85.3) ≤ P < 12 (170.7)
V < 45 (28)
45 ~ 100 (113 ~ 212)
LOW
100 (212) or above
HIGH
45 (28) ≤ V < 80 (49.7)
95 ~ 100 (203 ~ 212)
LOW
100 (212) or above
HIGH
80 (49.7) ≤ V
105 (221) or above
HIGH
12 (170.7) ≤ P < 15.5 (120.5)
V < 45 (28)
-30 ~ 95 (-22 ~ 203)
LOW
95 (203) or above
HIGH
45 (28) ≤ V < 80 (49.7)
95 ~ 100 (203 ~ 212)
LOW
100 (212) or above
HIGH
80 (49.7) ≤ V
105 (221) or above
HIGH
15.5 (120.5) ≤ P
All
-30 (-22) or above
HIGH

[Non-Air conditioning type]
The cooling fan operates in 1 stages (HIGH). The engine control module (ECM) controls the cooling fan according to the coolant temperature, vehicle speed and A/C operation.
[Cooling fan operation conditions]
A/C switch
A/C pressure
[kgf/cm² G (psi G)]
Vehicle speed
[km/h (mph)]
Coolant temperature
[°C (°F)]
Cooling fan speed
OFF

V < 45 (28)
95 ~ 100 (203 ~ 212) or above
HIGH
45 (28) ≤ V < 80 (49.7)
95 ~ 100 (203 ~ 212) or above
HIGH
80 (49.7) ≤ V
105 (221) or above
HIGH

    Cooling Fan Components
    1. Cooling fan mounting retainer 2. Torque washer 3. Cooling fan 4. Fan motor 5. Cooling fan shroud 6. Cooling fan resistor ...

    Cooling Fan Specifications
    Item Specification Motor capacity (W) 140 (With A/C) 120 (Without A/C) Fan type Puller Puller Fan speed control ...

    See also:

    Reduction Gear Oil Repair procedures
    Inspection 1. Lift the vehicle. 2. Remove the under cover. (Refer to Traction Motor System - "under cover") 3. Remove the oil filler plug (A). 4. Check the oil condition and then oil ...

    Accelerator Position Sensor (APS). Description and Operation
    Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

    Rear Hub - Carrier Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from ...