Kia Soul: Control Shaft Complete Removal - Manual Transaxle Control System - Manual Transaxle System - Kia Soul 2014-2019 PS Service ManualKia Soul: Control Shaft Complete Removal

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Removal

1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Set shift lever to "N" position.
4.
Remove the control cable from the control shaft after remove the pin (A) and washer (B).

5.
Remove the control shaft assembly after loosen the bolts.

Tightening torque:
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)

    Control Shaft Complete Description
    Component location : Control shaft assembly is mounted on the top of the manual transaxle Function : Change the gear by shifting a shift lever. ...

    Control Shaft Complete Installation
    1. Install in the reverse order of removal.    • ...

    See also:

    Customer Complaint Analysis Check Sheet
    Troubleshooting (Flow chart type) There are six areas where a problem can occur: wiring harness, the radio, the USB/iPod, and speaker. Troubleshooting enables you to confine ...

    Good driving practices
    Never take the vehicle out of gear and coast down a hill. This is extremely hazardous. Always leave the vehicle in gear. Don't "ride" the brakes. This can cause them to overheat ...

    Parking Brake Cable. Installation
    1. Install the parking brake cable (A). Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...