Kia Soul: Control Shaft Complete Installation - Manual Transaxle Control System - Manual Transaxle System - Kia Soul 2014-2019 PS Service ManualKia Soul: Control Shaft Complete Installation

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Installation

1.
Install in the reverse order of removal.
  
•
When installing, set control shaft lever to neutral position.
•
When installing, apply the sealant as shown in the illustration.
Specified sealant : LOCTITE 5060 or Anaerobic adhesives type J (For flange)

2.
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
    Control Shaft Complete Removal
    1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

    Manual Transaxle Oil
    ...

    See also:

    Rear Torsion Beam Axle Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

    Special Service Tools
    Tool Name / Number Illustration Description Engine support fixture (bar) 09200-3N000 Used for holding engine assembly when removing / in ...

    Engine compartment
    1.6 Gasoline 2.0 Gasoline 1. Windshield Washer Fluid Reservoir 2. Engine Oil Filler Cap 3. Engine Oil Dipstick 4. Engine Coolant Reservoir 5. Radiator Cap 6. Brake/Clutch Fluid Reservoir 7 ...