Kia Soul: Control Cable Removal
Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Removal
1. |
Shift lever to "4rd" gear position.
|
2. |
Rotating counter-clockwise shift lever knob (A).
|
3. |
Remove the floor console assembly.
(Refer to Body - " Floor Console")
|
4. |
Remove the rear heating joint duct (A).
|
5. |
Remove the bracket (A).
|
6. |
Remove the select cable (B) after removing the snap pin (A).
|
7. |
Remove the cable socket (C) from lever assembly after pulling
in the direction of the arrow.
|
8. |
Remove the shift cable (B) after removing the clip (A).
|
9. |
Remove the cable socket (A) from lever assembly after pulling
in the direction of the arrow.
|
10. |
Remove the retainer (A) after loosen the nut (B).
|
11. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
12. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
13. |
Remove the shift & select cable.
|
Control Cable Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...
Control Cable Installation
When installing, set room side shift lever and T/M side lever
to "4rd" gear position.
1.
...
See also:
Front Hub / Knuckle Installation
1.
Install in the reverse order of removal.
Use a SST (09581-11000) when ...
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives
the vehicle identification number (VIN). ...
If the engine will not start
If engine doesn't turn over or turns over slowly
1. If your car has an automatic transaxle, be sure the shift lever is in N (Neutral)
or P (Park) and the emergency brake is set.
2. Check the b ...