Kia Soul: Components and Components Location - BCM (Body Control Module) - Body Electrical SystemKia Soul: Components and Components Location

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / BCM (Body Control Module) / Components and Components Location

Components

Connector Pin Information
No.
Connector A (24 pin)
Connector B (20 pin)
Connector C (26 pin)
Connector D  (16 pin)
1
Battery (+)
LIN (PAS)
Washer motor power
-
2
IGN 1
Fuel filler (Charge door) actuator relay
Front washer motor
-
3
IGN 2
LS CAN high
-
-
4
Brake switch
LS CAN low
Mirror unfold relay
Mirror unfold switch
5
Wiper mist switch
Mood lamp unlock state
DRL lamp LH
Mirror fold switch
6
Crash unlock input (PWM)
Horn relay
DRL lamp RH
-
7
-
-
Room lamp
-
8
Fuel filler (Charge door) open switch
HS CAN low
-
-
9
Wiper washer switch
HS CAN high
-
Auto light switch
10
Wiper INT switch
Ground (Auot light)
-
Defogger switch
11
Wiper low switch
Auto light signal
-
-
12
Rear washer switch
Auto light power
Wiper low relay
Head lamp high switch
13
ACC
Safety power window enable high
-
Head lamp low switch
14
Wiper high switch
-
DRL lamp power
-
15
Front fog lamp switch
ATM solenoid
Rear washer motor
-
16
Rear wiper switch
-
Mirror fold relay
-
17
Rear INT switch
Fuel filler (Charge door) lamp
MTS Tx
?
18
-
-
-
19
-
-
Head lamp low signal
20
-
Ground (Power)
AV tail
21
Tail switch
?
Wiper high relay
22
Wiper INT volume
-
23
LIN (Intelligent Battery Sensor)
-
24
Ground (Signal)
-
25
?
-
26
Ground (Power)

    Specifications
    Specifications ItemsSpecificationsRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-30°C ~ 80°C (-4°F ~ 176°F)Dark currentBCM & Receiver : Max. 4 mABCM : Max. 3 mA ...

    Description and Operation
    Description BCM CAN Communication Function FunctionDescriptionTimerDefrosterWhen IGN ON, Rear Heater Control FunctionSafety Power WindowAccording to the position of key, Power Window Output C ...

    See also:

    Cluster ionizer Repair procedures
    Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal50Cluster ion generator fault * For diagnostic procedures ...

    Why didn't my air bag go off in a collision? (Inflation and non-inflation conditions of the air bag)
    There are many types of accidents in which the air bag would not be expected to provide additional protection. These include rear impacts, second or third collisions in multiple impact accidents, ...

    Sub Frame Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt (A) and then disco ...