Kia Soul: Component Location Index - Air conditioning System - Heating,Ventilation And Air ConditioningKia Soul: Component Location Index

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Component Location Index

Engine Room
[Gamma Engine]

1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Service Port (Low Pressure)
8. Service Port (High Pressure)
9. A/C Pressure Transducer (APT)
10. Expansion Valve

[Nu Engine]

1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Service Port (Low Pressure)
8. Service Port (High Pressure)
9. A/C Pressure Transducer (APT)
10. Expansion Valve

Interior

1. Photo Sensor
2. Heater & Blower Unit
3. Evaporator Temperature Sensor
4. Heater & A/C Control Unit (Manual)
5. Heater & A/C Control Unit (FATC)
6. Heater & A/C Control Unit (AVN)

    Refrigerant Leak Test
    Always conduct a leak test with an electronic leak detector whenever leakage or refrigerant is suspected and when conducting service operations which are accompanied by disassembly or looseni ...

    Compressor oil Specification
    1. The R-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

    See also:

    Installing a child restraint on a front passenger’s seat is forbidden
    Never place a rear-facing child restraint in the front passenger’s seat. If the air bag deploys, it would impact the rear-facing child restraint, causing serious or fatal injury. In addition, ...

    Sub Frame Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt (A) and then disconnect the universal joint assembly from the pin ...

    ICM (Integrated Circuit Module) Relay Box Repair procedures
    Inspection Normal Charge Port Relay Check for continuity between the terminals. 1. There should be continuity between terminals No.20 and No.10 when power and ground are connected to terminals ...