Kia Soul: Checking the brake/clutch fluid level - Brake/Clutch fluid - MaintenanceKia Soul: Checking the brake/clutch fluid level

Kia Soul (SK3) 2020-2020 Owners Manual / Maintenance / Brake/Clutch fluid / Checking the brake/clutch fluid level

Kia Soul. Checking the brake/clutch fluid level

Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.

Before removing the reservoir cap and adding brake/clutch fluid, clean the area around the reservoir cap thoroughly to prevent brake/clutch fluid contamination.

If the level is low, add fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings.

If the fluid level is excessively low, have the system checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

Use only the specified brake fluid. (Refer to “Recommended lubricants or capacities” on page 9-11.)

Never mix different types of fluid.

WARNING

Loss of brake/clutch fluid

In the event the brake/clutch system requires frequent additions of fluid, have the system Inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/ service partner.

WARNING

Brake/clutch fluid

When changing and adding brake/ clutch fluid, handle it carefully. Do not let it come in contact with your eyes. If brake/clutch fluid should come in contact with your eyes, immediately flush them with a large quantity of fresh tap water. Have your eyes examined by a doctor as soon as possible.

CAUTION

Do not allow brake/clutch fluid to contact the vehicle's body paint, as paint damage will result. Brake/ clutch fluid, which has been exposed to open air for an extended time should never be used as its quality cannot be guaranteed. It should be properly disposed. Don't put in the wrong kind of fluid. A few drops of mineral-based oil, such as engine oil, in your brake/ clutch system can damage brake/clutch system parts.

    Washer fluid
    Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solv ...

    See also:

    Hazard warning flasher
    The hazard warning flasher should be used whenever you find it necessary to stop the vehicle in a hazardous location. When you must make such an emergency stop, always pull off the road as far a ...

    Rear Transverse Trim Components and Components Location
    Component Location 1. Rear transverse trim ...

    Temperature control
    The temperature will increase to the maximum (HI) by turning the knob to the right extremely. The temperature will decrease to the minimum (Lo) by turning the knob to the left extremely. When ...