•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the center fascia panel
(A).
|
2. |
Disconnect the A/C & heater controller connectors (A).
|
3. |
Install in the reverse order of removal.
• |
Make sure the connector are connected in properly.
|
• |
Replace any damaged clips.
|
|
|
1. Center fascia panel
...
1. Crash pad lower panel
...
See also:
Sunshade
To open the sunshade
Press the sunshade open button (1). To stop the sliding at any point, press the
sunshade control switch momentarily.
To close the sunshade when the sunroof glass is closed ...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the engineroom under cover.
3 ...
Output Speed Sensor. Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed senso ...