Kia Soul: Brake Line Repair procedures - AHB(Active Hydraulic Boost) System - Brake SystemKia Soul: Brake Line Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Brake System / AHB(Active Hydraulic Boost) System / Brake Line Repair procedures

Removal
1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
   
Do not spill brake fluid on the vehicle as it may damage the paint. If brake fluid comes in contact with the paint, wash off immediately with water.
3.
Remove the wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
4.
Remove the brake hose mounting bracket bolt (A).

5.
Disconnect the brake tube by loosening the tube flare nut (B).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
Front

Rear

6.
Remove the brake hose clip (A).
7.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).
Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
Front

Rear

Inspection
1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3.
Check the brake tube flare nuts for damage and fluid leakage.
4.
Check brake hose mounting bracket for crack or deformation.
Installation
1.
Install in the reverse order of removal.
   
Use a new washer (A) whenever installing.

2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
3.
Check for brake fluid leaks.
    Brake Line Components and Components Location
    Components ...

    Brake Pedal Components and Components Location
    Components 1. Brake pedal stroke sensor2. Stop lamp switch3. Brake pedal ...

    See also:

    Heated Steering wheel Schematic Diagrams
    System Circuit Diagram ...

    A Pillar Garnish Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protec ...

    Brake Pedal Repair procedures
    Inspection Check that the brake pedal operates smoothly. Brake Pedal Height and Stop Lamp Switch clearance Adjustment 1. Disconnect the stop lamp switch connector (A). 2. Adjust the brake pe ...