Kia Soul: Brake Line. Removal - Brake System - Brake SystemKia Soul: Brake Line. Removal

Kia Soul 2014-2019 PS Service Manual / Brake System / Brake System / Brake Line. Removal

1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
  
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

4.
Remove the brake hose mounting bracket bolt (A).

5.
Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

6.
Remove the brake hose clip (A).
7.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Front

Rear

    Brake Line. Components
       When installing brake hose, be sure to comply with the torque specification to prevent twisted hose. ...

    Brake Line. Inspection
    1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

    See also:

    Canister Close Valve (CCV). Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the ...

    Installation
    1. Install the boot (A). 2. Install the clip to the clutch release fork. 3. Apply to grease in location ...

    Rear Door Window Glass Components and Components Location
    Component Location 1. Rear door window glass ...