Kia Soul: Brake Booster. Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
3. |
Remove the master cylinder.
(Refer to Brake System - "Master cylinder")
|
4. |
Disconnect the vacuum hose (A) from the brake booster.
|
5. |
Disconnect the vacuum pressure sensor connector (A) from the brake
booster.
|
6. |
Remove the snap pin (A) and clevis pin (B).
|
7. |
Remove the brake booster mounting nuts (A).
|
8. |
Remove the brake booster (A).
|
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Brake Booster. Inspection
1.
Inspect the check valve in the vacuum hose.
Do not remove the check va ...
See also:
Seat cushion height. Lumbar support
Seat cushion height
1. Pull the front portion of the control switch up to raise or press down to
lower the front part of the seat cushion. Pull the rear portion of the control switch
up to rais ...
Theft-alarm & Disarmed stage
Theft-alarm stage
The alarm will be activated if any of the following occurs while the system is
armed.
A door is opened without using the transmitter (or smart key).
The tailgate is opened w ...
Mode Pop up
[Mode Pop up]
Changes/
selection mode
During On state, press the
or
key to display the mode change pop up screen.
...