Kia Soul: Blower Resistor (Manual) Replacement - Blower - Heating,Ventilation And Air ConditioningKia Soul: Blower Resistor (Manual) Replacement

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Resistor (Manual) Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

4.
Install in the reverse order of removal.
    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

    Field Effect Transistor (FATC) Inspection
    1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. ...

    See also:

    Crankshaft Position Sensor (CKPS). Repair procedures
    Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal ...

    Multimedia Jack Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor ...

    In case of an emergency while driving
    If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you h ...