Kia Soul: BJ Boot Components - Driveshaft Assembly - Driveshaft and axleKia Soul: BJ Boot Components

Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Components

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ housing
13. TJ circlip

    Dynamic Damper Installation
    1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

    BJ Boot Replacement
    1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refe ...

    See also:

    Purge Control Solenoid Valve (PCSV). Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between th ...

    Certification label
    The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Ve ...

    Checking the coolant level
    WARNING Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in seriou ...