Kia Soul: Battery Adjustment - Charging System - Engine Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Battery Adjustment

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Charging System / Battery Adjustment

Battery Charging
In general, vehicle battery charging system has three forms.
1.
Constant current charge: The battery voltage gradually rises by charging with setting a constant current. If charging current and time are not managed correctly, the battery is over-charged, therefore charging should be stopped after confirming the completion of charging.
A.
General charge: Charging the battery for a long time with low current
B.
Quick charge: Charging the battery for a short time with high current
2.
Constant voltage charge: The battery charge current is gradually reduced by charging with setting a constant voltage.
3.
Constant current-Constant voltage charge: Charging with constant current and voltage to protect the battery damage
(1)
Initial Stage: Charging with constant current
(2)
Last Stage: Charging with constant voltage
  
Refer to the instruction manual provided by the battery charger equipment manufacturers for detailed charging procedures and precautions.
    Battery Components
    1. Battery insulation pad 2. Battery 3. Battery tray 4. Battery mounting bracket ...

    Battery Removal
    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable (A). 2. Disconnect the positive (+) terminals (B) from the ba ...

    See also:

    Closing the tailgate
    To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING - Exhaust fumes Driving with the tailgate open is not advisable. Dangerous ...

    TPMS Sensor. Diagnosis procedure by using diagnostic device
    As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

    Refrigerant Leak Test
    Always conduct a leak test with an electronic leak detector whenever leakage or refrigerant is suspected and when conducting service operations which are accompanied by disassembly or looseni ...