Kia Soul: Automatic heating and air conditioning
1. Push the AUTO button. It is indicated by AUTO on the display. The modes, fan speeds, air intake and air-conditioning will be controlled automatically by temperature setting.
2. Push the temperature control button to set the desired temperature. (Type A)
Turn the temperature control knob to set the desired temperature. (Type B)
✽ NOTICE
- To turn the automatic operation off, select any button or switch of the
following: - Mode selection button
- Air conditioning button
- Front windshield defroster button
- Air intake control button
- Fan speed control switch The selected function will be controlled manually while other functions operate automatically. - Regardless of the temperature setting, when using automatic operation, the air conditioning system can automatically turn on to decrease the humidity inside the vehicle, even if the temperature is set to warm.
Never place anything over the sensor located on the instrument panel to ensure better control of the heating and cooling system.
Automatic climate control system
1. Temperature control button / knob
2. Front windshield defroster button
3. Rear windshield defroster button
4. Climate control display
5. Air intake control button
6. Air conditioning butto ...
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons
other than the AUTO button.
In this case, the system works sequentially according to the order of buttons
selected.
W ...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description
Overdrive clutch control solenoid valve(OD/C) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the overdrive clutch.
...
Auto Light Sensor Inspection
In the state of IGN1 ON, when the multi function switch module detects
auto light switch on, tail lamp relay output and head lamp low relay output
are controlled according to auto light se ...
Compressor oil Specification
1.
The R-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...