Kia Soul: Auto Head Lamp Leveling Unit Inspection - Auto Head Lamp Leveling Device - Body Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Auto Head Lamp Leveling Unit Inspection

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Inspection

1.
Ignition "ON".
2.
Turn on the head lamp switch.
3.
Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned.
4.
If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 5.
5.
Substitute with a known-good head lamp assembly and check for proper operation.
    Auto Head Lamp Leveling Unit Operation
    Operating Procedure 1. Suspension angle change resulted from vehicle's load change. 2. Sensor angle change. ...

    Auto Head Lamp Leveling Unit Removal
    1. Remove the head lamp leveling unit connector (A). 2. Remove the head lamp leveling unit (B) after loosening the mountin ...

    See also:

    Brake Booster Operating Test
    For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

    Mode Control Actuator Description
    The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

    Shift Lever Installation
    1. Install in the reverse order of removal.    When installing, set room sid ...