Kia Soul: Audio Remote Control Removal - Audio - Body Electrical SystemKia Soul: Audio Remote Control Removal

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Audio / Audio Remote Control Removal

[Upper Steering Wheel Remote Control Switch]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group)
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Loosen the mounting screws from the rear steering wheel cover.

5.
Separate the upper steering wheel remote control switch (A) from the steering wheel.
[LH]

[RH]

6.
Remove the upper steering wheel control switch (B) disconnecting the connector (A).
[LH]

[RH]

[Lower Steering Wheel Remote Control Switch]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group)
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Loosen the mounting screws from the rear steering wheel cover.

5.
Separate the upper steering wheel remote control switch (A) from the steering wheel.
[LH]

[RH]

6.
Remove the upper steering wheel control switch (B) disconnecting the connector (A).
[LH]

[RH]

7.
Separate the lower steering wheel control switch (A) loosening the mounting screws.
[LH]

[RH]

8.
Remove the lower steering wheel control switch (B) disconnecting the connector (A).
[LH]

[RH]

    Audio Remote Control Inspection
    1. Check for resistance or output voltage between terminals in each switch position. [Audio] Switch Connector terminal ...

    Audio Remote Control Installation
    1. Install the remote control switch on the steering wheel. 2. Install the steering wheel. 3. Reconnect the rem ...

    See also:

    Removal
    1. Remove the clutch pedal mounting nuts (A). 2. Separate the push rod (C) after remove the pin (A) and washer (B). ...

    Cylinder Head Cover Components
    1. Cylinder head cover 2. Cylinder head cover gasket 3. Cam position sensor ...

    Battery Sensor Installation
    1. Install in the reverse order of removal. Battery sensor cable installation bolt: 26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 l ...