Kia Soul: Alternator Specification - Charging System - Engine Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Alternator Specification

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Charging System / Alternator Specification

Alternator
ltem
Specification
Nominal output
13.5V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C 
Internal mode
-3.5 ± 2mV / °C
Target voltage data (COM)
Frequency (Hz)
115 ~ 500
Signal type
PWM
Voltage level (V)
High: 3.5 ± 0.2
Low: 1.5 ± 0.2
Electric load (FR)
Frequency (Hz)
250 ± 38
Signal type
PWM
Current limitation from vehicle (mA)
2.7 ~ 7.0

※ Regulator Setting Voltage (External mode)

    Alternator Description
    The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

    Alternator Components
    1. Overrunning Alternator Decoupler (OAD) pully 2. Front bracket 3. Front bearing 4. Stator 5. Rotor 6. Rear bearing 7. Rear housing 8. Regulator assembly 9. Thr ...

    See also:

    Telemetics Unit (TMU) Component
    Connector Pin Specification No. Pin Name Type From To Description (Wiring Spec.) 1 GND DC Ground ...

    Repeat
    Press the key Set [ RPT] through the TUNE knob or key to repeat the current song. ❈ Press RPT again to turn off. ...

    Components Location
    1. Automatic transaxle 2. Inhibitor switch 3. Transaxle Control Module (TCM) 4. Valve body cover 5. Solenoid valve connect 6. Oil temperature sensor 7. Valve body assembly ...