Kia Soul: Air Ventilation Seat Control Unit Removal - Seat Electrical - Body Electrical SystemKia Soul: Air Ventilation Seat Control Unit Removal

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Seat Electrical / Air Ventilation Seat Control Unit Removal

Cushion Blower
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the cushion blower (B) after loosening the screws and disconnecting the connector (A).

Back Blower
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
3.
Disconnect the connector (A) and fatsners (B).

4.
Remove the back blower (A) after loosening the mounting screws.

Air Ventilation Unit
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the air ventilation unit (A) after loosening the screws and disconnecting the connector.
[Drive's Side]

[Passenger's Side]

    Air Ventilation Seat Control Unit Description
    The ventilated seat system uses a Push method to cool the seat. A blower mounted in the seat generates the cool air, which then travels through ducts to the seat back and cushion. ...

    Air Ventilation Seat Control Unit Installation
    Cushion Blower 1. Install the cushion blower. 2. Install the front seat assembly. Back Blower ...

    See also:

    Description
    Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

    Battery Repair procedures
    Inspection Battery Voltage and Status Check the battery voltage and status using the battery tester. Battery Terminal 1. Move back and forth to check that the battery terminals (A) are loose or ...

    Tail lamp / Back up lamp bulb replacement (Rear combination lamp Type A)
    1. Open the tailgate. 2. Remove the service cover. (Loosen the lamp assembly retaining screws and remove the lamp assembly from the body of the vehicle for back-up lamp) 3. Remove the socket f ...