Kia Soul: Accelerator Position Sensor (APS). Description and Operation
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine control system, so it consists of the
two sensors which adapt individual sensor power and ground line. The second
sensor monitors the first sensor and its output voltage is half of the first
one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2),
the diagnostic system judges that it is abnormal.
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...
Accelerator Position Sensor (APS). Specifications
Specification
Accelerator
Position
Output Voltage (V)
[Vref = 5V]
APS1
APS2
C.T
0.7 ~ 0.8
0.28 ~ 0.48
W.O.T
3.8 ...
See also:
Horn
To sound the horn, press the horn symbols on your steering wheel. Check the horn
regularly to be sure it operates properly.
✽ NOTICE
To sound the horn, press the area indicated by the h ...
Pre-charge Relay Schematic Diagrams
System Circuit Diagram
With High Voltage Battery Heater System
Without High Voltage Battery Heater System
Circuit Diagram
Without High Voltage Battery Heater System
With High Voltage Batt ...
Front Door Side Weatherstrip Repair procedures
Replacement
1.
Loosen the front door checker (B) mounting bolt.
Tightening torque :
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m,12.3 ~ 15.9 lb-ft)
2.
Detach the clips, and then remove the front doo ...